Master of Science in Process Technology: Nye registreringer
Viser treff 161-177 av 177
-
Aspen HYSYS process simulation and Aspen ICARUS cost estimation of CO2 removal plant
(Master thesis, 2010-06-25)An Aspen HYSYS model of CO2 removal was developed and modified with a split-stream configuration in order to reduce energy consumption in the reboiler. The model has been calculated with variation of parameters to optimize ... -
Alternative fuels in cement kilns - characterization and experiments
(Master thesis, 2010-05-04)In this thesis, the possibilitites and limitations of using alternative fuels in cement kilns are considered. -
CO2 BLEVE (Boiling Liquid Expanding Vapor Explosion)
(Master thesis, 2009-06-26)Boiling Liquid Expanding Vapor Explosion (BLEVE) has caused many accidents in industry, while research with BLEVE is still limited with scarcity of experimental data. Among all pressurized liquefied gases (PLGs), CO2 plays ... -
Supported ionic liquids as CO2 adsorbants
(Master thesis, 2008)Denne rapporten er delt inn i to deler, en teori del, og en eksperimentell del. Den teoretiske delen beskriver teori om ioniske væsker og adsorpsjon. Dette er for å få et grunnleggende forståelse av den eksperimentelle ... -
Recommendation of a model for simulating & analysis of the influence of particle size distribution on the simulations of bubbling fluidized beds
(Master thesis, 2008-06-06)A computational study of the influence of particle size distribution on bubbling fluidized beds is performed. Several simulations are performed using Eulerian multiphase model for a two dimensional fluidized bed with an ... -
Biodegradation of waste amines under anaerobic, micro-aerobic and aerobic conditions
(Master thesis, 2008)Monoethanolamines (MEA) are commonly used as adsorbent in CO2 capture plants. MEA are degraded when used and become a waste product. 3 series of BOD test as well as 9 cases of syringe batch experiments under anaerobic, ... -
Modeling and simulation of post combustion CO2 capturing
(Master thesis, 2008)A dynamic model for the chemical absorption of carbon dioxide in Monoethanolamine is developed and implemented. The model includes absorption tower, de-absorption tower, reboiler, condenser and rich/lean heat exchanger. ... -
CO2 absorption in alkaline solution
(Master thesis, 2008)Density and viscosity for monoethanolamine (MEA) solution are important for estimation of mass transfer in CO2 removal by absorption. A literature search on density, viscosity, surface tension and contact angle was performed. ... -
CFD study of a fluidized bed
(Master thesis, 2008)The aim of this thesis is to investigate the momentum exchange between the phases in a bubbling fluidized bed. The momentum exchange can be described by a drag model. Several drag models with different assumptions are ... -
Control system for mass flow rate of solids in pneumatic conveying
(Master thesis, 2008-06-06)The aim of the thesis is to make a model of the mass flow rate of solids in the pneumatic conveying systems situated at the POSTEC/Tel-Tek research facility to be used for the testing of model predictive control of these ... -
Experimental study of bubbling fluidized bed
(Master thesis, 2008-06)A series of experiments are performed in order to study the flow behaviour of bubbling fluidized bed. A two dimensional fluidized bed is built up with dimension 0.8 m (height) × 0.2 m (width) × 0.025 m (depth) and uniform ... -
Spredning og antenning av hydrogen - Background Oriented Schlieren (BOS) visualisering
(Master thesis, 2007)Rapporten er delt inn i tre deler. Første del er et litteraturstudie som omhandler tidligere undersøkelser og evalueringer av ”Background Oriented Schlieren”-fotografering (BOS) og hvilke anvendelsesområder den kan ... -
Duggpunktskontroll for gassinjeksjon og gasseksport ved Oseberg Feltsenter
(Master thesis, 2007)Naturgassen som tas opp fra gassfeltet Oseberg Feltsenter gjennomgår en rekke prosesser før eksport og injeksjon. En viktig prosess for å oppnå spesifikasjonskrav er gasstørking. Dette gjøres ved å bruke TEG, som er en ... -
Computational study of heat transfer in subsea deadlegs for evaluation of possible hydrate formation
(Master thesis, 2007)The background for this project is the request of achieving more knowledge of the temperature and velocity fields in different subsea deadleg geometries. This is important to avoid hydrate formation in subsea equipment. ... -
Effekten av syklisk belastning under konsolidering og styrkeprøving i en uniaxialtester
(Master thesis, 2005)For industri som bruker, behandler eller produserer partikulære materialer (pulver), er ofte de partikulære materialenes flytegenskaper av avgjørende betydning for prosessene eller for produktene. Mange bedrifter innenfor ... -
Redundans ved bruk av masse- og varmebalanser for plattformprosesser
(Master thesis, 2005)Institutt for energiteknikk (IFE) har i flere år arbeidet med bruk av balanseligninger sammen med måledata for å overvåke systemer i kjernekraftanlegg. Gjennom data reconciliation (datatilpasning) kan redundans i målingene ... -
Design av desentraliserte og suboptimale regulatorer for diskrete systemer
(Master thesis, 2005)Denne rapporten beskriver hvordan optimaliseringproblemet knyttet til optimalregulering, kan løses ved hjelp av optimaliseringsrutiner. En algoritme er laget og implementert i MatLab versjon 6.5 (R13) for optimal innstilling ...