Blar i Institutt for prosess-, energi- og miljøteknologi på tittel
Viser treff 45-64 av 331
-
Capital cost estimation of CO2 capture plant using Enhanced Detailed Factor (EDF) method: Installation factors and plant construction characteristic factors
(Journal article; Peer reviewed, 2021)Capital cost is frequently estimated for new and retrofit carbon capture plants as new concepts for cost reduction emerge. Capital cost during initial cost estimation of chemical plants strongly depends on the installation ... -
Carbon dioxide emission reduction by increased utilization of waste-derived fuels in the cement industry
(Conference report, 2007)Considerable reductions in Norway's emissions of greenhouse gases like CO2 are required to meet the commitments of the Kyoto Protocol. CO2 emissions from cement clinker production originate from decarbonation of limestone ... -
Carbon dioxide solubility in mixtures of methyldiethanolamine with monoethylene glycol, monoethylene glycol–water, water and triethylene glycol
(Peer reviewed; Journal article, 2020)Carbon dioxide solubility in non-aqueous and aqueous mixtures of methyldiethanolamine (MDEA) with monoethylene glycol (MEG) was studied due to the relevance of these solvents for the combined acid gas removal and hydrate ... -
Case studies of CO2 capture columns based on fundamental modeling
(Conference object; Peer reviewed, 2012-03-29) -
Categorising area models for stormwater fees at propert level: A literature review
(Journal article, 2022)Worldwide, the increasing challenges due to stormwater run-off in urban areas are well known. Authorities need to be prepared for emergency situations and have plans for preventive measures to avoid flooded properties and ... -
CCS in the Skagerrak/Kattegat area
(Journal article; Peer reviewed, 2011-04-01)This paper presents an ongoing project with the aim to assess a CO2 infrastructure in the Skagerrak/Kattegat region (the sea bordered by north of Denmark, south coast of Norway and the west coast of Sweden). The area ... -
CFD Study of Particle Flow Patterns in a Rotating Cylinder Applying OpenFOAM and Fluent
(Journal article; Peer reviewed, 2017)A rotating cylinder (RC) is a common type of reactor used in the industry, the most typical example being a cement kiln. The particle flow pattern inside such a unit is necessary for the mass and energy transfer, and this ... -
Characterization of a medium velocity deluge nozzle for offshore installations
(Peer reviewed; Journal article, 2021)It is important to study the characteristics of the nozzle of the deluge spray to comply with the standards developed by the petroleum industry for offshore installations in Norway. Due to the stochastic nature of the ... -
Characterization of biomass wood
(Journal article; Peer reviewed, 2016)Biomass is a renewable energy resource and can replace the use of fossil fuels, such as coal. Overgrown forests and fields are about to become a noticeable problem, because the rate of woodcutting is too low compared with ... -
Chemical equilibrium model to investigate scaling in moving bed biofilm reactors (MBBR)
(Peer reviewed; Journal article, 2019)Moving bed biofilm reactor (MBBR) is a robust, flexible and compact technology for treatment of medium to high strength wastewater. However, while treating with high concentration of ammonium, phosphorus and metal ions, ... -
Circulating fluidized bed reactors – part 01: analyzing the effect of particle modelling parameters in computational particle fluid dynamic (CPFD) simulation with experimental validation
(Peer reviewed; Journal article, 2019)A CPFD hydrodynamic model was developed for a circulating fluidized bed system and the simulation results were validated against experimental data based on particle circulation rate. Sensitivity of the computational mesh ... -
CO2 Absorption Efficiency and Heat Consumption Measured at High Gas to Liquid Ratios in Laboratory Rig
(Journal article; Peer reviewed, 2017)A laboratory rig for CO2 absorption into amine solvents including desorption has been in operation at University College of Southeast Norway for several years. Measurements of CO2 removal efficiency and heat consumption ... -
CO2 Capture by Aqueous 3-(Methylamino)propylamine in Blend with Tertiary Amines: An NMR Analysis
(Journal article; Peer reviewed, 2017)Aqueous 3-(Methylamino) propylamine (MAPA) in blend with 2-(Diethylamino) ethanol (DEEA) and other tertiary amines, which mainly differ from DEEA in the number of hydroxyl functions (-OH) and/or in the length and structure ... -
CO2stCap - Cutting Cost of CO2 Capture in Process Industry
(Journal article; Peer reviewed, 2017)This paper is a presentation of the CO2stCap project to be undertaken in the four year project period (2015 – 2019). The project focuses on partial CO2 capture in process industry and how this can be applied to reduce cost. ... -
Combined calcination and CO2 capture in cement clinker production by use of electrical energy
(Chapter, 2019)The technical feasibility of electrifying the calcination process in a precalciner cement kiln system was assessed by studying different electrification concepts. Resistance-based heating was selected as it equires no CO2 ... -
Comparison of experimental and computational study of the fluid dynamics in fluidized beds with agglomerates
(Peer reviewed; Journal article, 2020)Particle agglomeration is one of the obstacles for successful application and commercial breakthrough of fluidized bed biomass gasification. The problem is generally associated with molten ash components that interact with ... -
Comparison of OpenFoam and ANSYS Fluent. Compitational Fluid Dynamic Simulation of Gas-Gas Single Phase Mixing with and without Static Mixer
(Chapter; Peer reviewed, 2016)Gas-gas single phase mixing were numerically evaluated with static mixer and without static mixer using OpenFoam and ANSYS Fluent codes. The main goal was the gas-gas mixing simulation comparison between ANSYS Fluent and ... -
Comparison of simulation tools to fit and predict performance data of CO2 absorption into monoethanol amine at CO2 Technology Centre Mongstad (TCM)
(Journal article; Peer reviewed, 2018)n this work, several sets of experimental data from the amine based CO2 capture process at CO2 Technology Centre Mongstad (TCM) have been compared with simulations of different equilibrium based models and a rate-based ... -
Comparison of the influence of drag models in CFD simulation of particle mixing and segregation in a rotating cylinder
(Journal article; Peer reviewed, 2017)CFD modelling was used to simulate particle segregation in a transverse plane of a rotating cylinder under different particle-particle drag models. The Eulerian method was used to model the dense particulate phases in the ... -
Composite Distribution Solution for Minimizing Heat Loss in a Pyrolysis Reactor
(Journal article; Peer reviewed, 2011)The article presents a novel design for a distribution plate. The solution is suitable for a reactor vessel where a reactant gas needs to be maintained at a different temperature from the reaction chamber in order to avoid ...